Table of Contents
Advertisement
Satellite Search (acquisition) function works automatically
When JUE-501/JUE-251 is turned on, the system automatically calculates the satellite position by
measuring ship's position by GPS (built-in), and then automatically turns the antenna towards the
satellite.
After acquiring the satellite, the JUE-501/JUE-251 automatically controls the antenna angle to
maximize receiving signal strength.
LCD screen of Handset displays "CS PS READY" when communication is available.
If the communication fails although LCD screen shows [CS PS READY], low level of receiving
signal strength is suspected. Try the communication again after a while.
Initialization of the unit may take more than 5 minutes to complete. During this time, "CS PS
READY" may not be displayed on the screen. It is not abnormal status (the JUE-501/JUE-251 is
executing the initialization, satellite search, and registering to the network).
Please confirm that the GPS you are using reports proper position. (Refer to [7.1.3 Position status
display],p7-6).
Contact the purchasing dealer, JRC agent or one of the JRC branches with confirming above
matter, when the satellite search function does not work.
"SEARCH NG" is displayed in status column of Handset screen, when automatic satellite search
function is failed. In this case, carry out satellite acquisition again manually after checking that
there is no obstacle between the antenna and the satellite (refer to [4.2.3. Setting satellite search])
(p4-14). If satellite search was not executed manually, JUE-501/JUE-251 will restart satellite
search automatically after 10 minutes.
NOTE
NOTE
APAC E143.5
14:03 UTC
SEARCH NG
Fig. 4.1.3b SEARCH NG status of Idle screen
4-7
4. Getting started
Advertisement
Table of Contents
