JRC JUE-501 Instruction Manual page 105

5.2.4 Handling Call Waiting
You may hear a call waiting Indication during talking on the phone. The call waiting Indication tone
is two beeps every three seconds. To handle call waiting, the phone must have
replaced by pushing hook button of the phone for short time. Enable / disable call waiting is
performed by Web setting (refer to [6.5.2.3 Set Telephone Supplementary Service (p6-40)]).
Follow the procedure below as desired.
Hold the current call, and accept the waiting call.
Press R 2 #, during the call waiting indication
is ringing.
To exchange the held call for the active call,
press R 2 #.
To clear the active call and back to the held
R 1 #.
call, press
Reject the waiting call.
Press R 0 #.
These functions have not been supported yet.
A new version supporting them will be released at the end of March 2014.
5.2.5 Holding on the line
To hold a call on, the phone must have
phone for short time.
Follow the procedure below as desired.
Place a call on hold.
Press R 2 #, during the call is active.
Place the existing call on hold and establish a new call.
R
Press and dial the second phone number followed
by #.
Example) Establishing new call to +81422-45-9xxx in
Japan → R 0081422459xxx
The BGAN system supports only one Call Waiting at the same time.
Clear the current call, and accept the waiting call.
Press R １ #, during the call waiting indication
is ringing.
Ignore the waiting call.
Just ignore the waiting call indication (take no
action).
R R
key. key can be replaced by pushing hook button of the
Exchange held call for active call.
Press
Clear the active call and back to the held call.
Press
Clear the holding call (if no waiting call exists).
#
Press
NOTE
5-35
5. How to use the Telephone/FAX
R R
key. key can be
R 2 #.
R 1 #.
R 0 #.