Table of Contents
Advertisement
6.5.2.2 Set Auto Answering the Telephone (PBX Screen)
To enter the PBX screen, open "Telephony" menu on the left [menu] panel and select "PBX".
In this menu, user can set up auto answer. When auto answer is enabled, a fixed message (Please
dial 3 digits extension number.) is reproduced automatically. The main unit waits for input from the
caller for set time. If no input is recognized, the call will be forwarded to the default destination.
The extension number of JUE-501/JUE-251 is designed as Table 6.5.2.2a.
Table. 6.5.2.2a Extension Number JUE-501/JUE-251
Device
Handset
TEL1~TEL6
ALL TEL ports and Handset
IPTEL1 ~ IPTEL6
(Release software at end of 2013 will support)
ISDN
All
1)
2)
Table. 6.5.2.2b Contents of PBX-Auto Answer
Display
1)
Control
2)
Incoming Type
3)
Extension Number
4)
Limit Time
5)
SET
* Auto Answer function is not available when the land telephone can not handle DTMF.
* Auto Answer function answers the call even when the receiver is absent, and thus the
communication charge will be incurred.
* JRC is indemnified for any communication fee troubles using this function except as
outlined in the product warranty and by limitation of law.
3)
4)
Fig. 6.5.2.2a PBX Screen
Validation of Auto Answer
Incoming service type (Voice/Audio) for adapting auto answer
Default destination for forwarding a call when no input had been recognized
for "Limit Time".
*The call will not be forwarded when the terminal doesn't accept the service
type specified at "2) Incoming Type". Check your Telephony settings
(Sec.6.5.2.1).
Waiting time for input from caller
Registers the setting contents
NOTE
6-39
6. Web Menu System
Extension Number
000
001~006
099
501～506
401
999
5)
Contents
Advertisement
Table of Contents
