Table of Contents
Advertisement
6. Web Menu System
6.5.3.4 Set Input/Output signal (I/O Screen)
To enter the I/O screen, open "Port" menu on the left [menu] panel and select "I/O".
On this screen, user can set input/output of acknowledgement/indication from/to the
device connected to the Junction Board. A maximum of two output devices and two
input devices can be connected to Junction Board at a time.
1)
2)
1)
2)
3)
5)
Output / Input
1)
Control
2)
Function
3)
Polarity
4)
Set
Function
5） Type
6)
Set
Fig. 6.5.3.4 I/O Screen
Table 6.5.3.4 Contents of I/O Screen
Use or non-use of the I/O port
Function of "Output" is fixed at "Ring Indication" and that of "Input" is
also fixed at "Ring Acknowledge" in current version.
"Active High" means the function is executed by the higher of two voltages.
"Active Low" means the function is executed by the lower of two voltages.
(For the Output devices, "Active High" and "Active Low" is controlled by
their connection to the Junction Board.)
Registers the Output / Input settings.
Select the service type to activate output.
Registers the Function settings.
6-46
4)
4)
6)
Contents
Contents
Advertisement
Table of Contents
