Calling Internal Phone; Allocated Extension Number; Answering The Internal Call - JRC JUE-501 Instruction Manual

5.1.6 Calling Internal Phone

Hook off the Handset and press
Device
Handset
TEL1~TEL6
All TEL ports and Handset
ISDN (Set PBX-MSN. Refer to p6-43.)
IPTEL1 ~ IPTEL9
(Release software at end of 2013 will support)
All
When the party answers the call, [On Communication screen for Internal Phone] is displayed.
Return Handset to the cradle when the telephone call ends. [Disconnection screen] is displayed for
15 seconds with Cause Code and duration of communication. After the call has been completed,
the display returns to [Idle screen].
APAC E143.5
14:03 UTC
READY
Internal
COMM(OUT)
CS PS READY
After 15 seconds, the screen
returns to [Idle screen]
Fig.5.1.6a Flow of making a call

Answering the Internal call

If the Handset receives an internal call, ring tone will sound and the
screen changes to [Arrival screen for internal call].
Take up the Handset from the cradle, then you can talk with the party.
The screen will change to [On communication screen for internal
call]. After the disconnection, return the Handset to the cradle.
# and the extension number listed in table below.
Table 5.1.6 Allocated Extension Number
Idle screen
[Idle screen] is displayed when Handset is placed on the cradle, and
[Dial-waiting screen] is displayed when Handset is off-hooked.
Dial-up screen
#001
Enter the extension number.
On Communication screen for Internal call
T E L 1
The device you are connecting is displayed on the second line
until the call is disconnected..
Communication terminated screen
Return the Handset to the cradle.
The screen returns to [Idle screen] after 15 seconds.
*Cause Code: 4-digit code. Identities the cause of
disconnection (refer to [Appendix O Cause Code])
5-13
5. How to use the Telephone/FAX
Allocated number
000
001~006
099
401
501~509
999
Ring
Fig.5.1.6b Arrival screen for internal call
TEL1
COMM(IN)