Secondary Service; Contents Of Secondary Service Type Menu - JRC JUE-501 Instruction Manual

● Secondary Service
When a service type is selected for Secondary Service Type, Secondary Service Type menu will appear.
Set the Secondary Service Type and click Set button.
When "Secondary Service" is set to other than "Prohibit" and connect "Secondary Service" on Data
Connection screen, it holds two lines for one Global IP address.
Packet data within the "Uplink Traffic Flow Filter" or "Downlink Traffic Flow Filter" pass through the

Secondary Service.

Fig. 6.5.5.1g Secondary Service Type menu
Table 6.5.5.1g Contents of Secondary Service Type menu
Display
1) Secondary Service
2) max rate
3) Set
Uplink Traffic Flow Filter
Destination Address
4)
Subnet Mask
5)
Protocol No.
6)
Destination Port Range
7)
Source Port Range
8)
1)
2)
4)
5)
6)
7)
8)
9)
10)
11)
12)
13)
14)
15)
16)
17)
Service type for secondary service
Max rate for secondary service. (For Streaming service only.)
Registers the Secondary Service settings.
Destination address adapting Uplink Traffic Flow Filter
When it remains blank, the filter is adopted to all IP address.
Subnet mask for adapting Uplink Traffic Flow Filter
Protocol number for adapting Uplink Traffic Flow Filter
Range: 1 to 255
When it remains blank, the filter is adopted to all protocols.
Destination Port Range for adapting Uplink Traffic Flow Filter
Range: 1 to 65535. "-" represents range. Ex) 20-80 set from 20 to 80.
When it remains blank, the filter is adopted to all TCP/UDP port.
Source Port Range for adapting Uplink Traffic Flow Filter
Range: 1 to 65535. "-" represents range. Ex) 20-80 set from 20 to 80.
When it remains blank, the filter is adopted to all TCP/UDP port.
6-59
6. Web Menu System
3)
Contents
Contents