Screen Display Of Handset , When Jb /Gyro Are Used - JRC JUE-501 Instruction Manual

C.3 Screen display of Handset , when JB /GYRO are used (Corresponded to Chapter 4.1.4)
ON
Initializing
Initialize
Initial Heading value requesting
Headi ng ？
Satellite searching
APAC E143.5
14:03 UTC
SAT SEARCH
Registering to network
APAC E143.5
14:03 UTC
REGISTERING
Communication available status
APAC E143.5
14:03 UTC
CS PS READY
[READY]
lamp lit.
Turn on JUE-501/JUE-251 by pushing
power switch of Main unit.
A LED of Main unit starts blinking.
About 90 seconds later, initializing is started
and blinking [Initialize] text is displayed.
Input Heading value when it is required.
Note) this screen appears when:
• GYRO type is SYNC/STEP, and an
initial Heading value is not set yet.
• GYRO type
JUE-501/JUE-251
Heading information from GYRO.
[SAT SEARCH] text is displayed in the
lowest, [Status] line.
started.
Satellite search is terminated and then
[REGISTERING] text is displayed.
Registering to Inmarsat network is started.
Registering is terminated and [CS PS
READY] text is displayed.
Various services are available. (About the
operation after this screen, refer to chapter
4.1.4 or later).
Fig.C.3 Screen display of Handset
(when JB/GYRO are used)
C-3
Appendix C Junction Board
Changed
is NMEA, and
cannot obtain
Satellite search is