6. Web Menu System
8)
Global IP
9)
Set Default
10)
Advance Mode
11)
Set
■ Advance Mode
When Advance Mode button (explained by 10) of Table 6.5.5.1a) is clicked, the Advance Mode button
will change into Normal Mode button and advanced configuration will be displayed.
1)
2)
3)
4)
5)
6)
Fig. 6.5.5.1b WAN Profile Advanced Screen
Table 6.5.5.1b Contents of WAN Profile Advanced Screen
Display
1)
Normal Mode
2)
Connection Mode
3)
Packet Detect Activate
There is a possibility to connect unexpected PS Connection by the settings or
•
operation of terminal connected to Ethernet port. And if packet was sent or
received through this connection, communication fee will be charged. Thus be
careful to block an unexpected packet by using Packet Filter and modifying
settings of the terminal etc.
JRC is indemnified for any communication fee troubles using this function
•
except as outlined in the product warranty and by limitation of law.
Distribution partner of SIM card might charge a communication fee by only
•
connecting and disconnecting Standard IP Connection.
Select Dynamic or Static for Global IP address used in this profile.
Global IP address is required only when Static is selected.
Reset the settings to the default.
Get into advanced configuration. (Refer to Table 6.5.5.1b)
Registers the profile.
Hides advanced configurations.
Selection for Communication Mode.
"1by1 NAT" is set as a default.
LAN Group selection menu will appear when "IP Masquerade" is
selected. (Refer to Table 6.5.5.1c-d)
VLAN selection menu will appear when "Bridge" is selected. (Refer to
Table 6.5.5.1c-d)
Click Set button to activate the setting.
Packet Detect Activate is a function that automatically connects Standard
IP Connection by detecting outgoing packet when main unit is ready to
connect PS Connection (PS READY). The Standard IP Connection
connected by this function will be disconnected by Auto disconnect
function if Auto disconnect function is activated.
NOTE
6-54
Contents