Table of Contents
Advertisement
6. Web Menu System
1)
Fig. 6.5.5.1c Connection Mode menu (IP Masquerade)
1)
Fig. 6.5.5.1d Connection Mode menu (Bridge)
Table 6.5.5.1c-d Contents of Connection Mode menu
Display
1)
Connection Mode
2)
LAN Group
2)'
Target
3)
Set
● WAN Filter
When "Enable" is selected for WAN Filter, WAN Filter menu will appear. A maximum of 30 WAN
filters can be set for each WAN profile. JUE-501/JUE-251 can pass/drop an incoming/outgoing
packet by setting. It has no filters in the initial state, so it will pass all packets.
JUE-501/JUE-251 gives higher priority to MAC filter ([Sec. 6.5.5.6 Further Settings for User LAN
(p6-70)]) than any other WAN filter. There is no preference between WAN filters and packet filters
([Sec. 6.5.5.2 Set Packet Filter (p6-61)]). Just coordinate the "Priority" to make the preference.
JUE-501/JUE-251 gives higher priority to Packet Filter when the same "Priority" was set to a Packet
filter and a WAN filter.
2)
3)
4)
2)
2) '
Selection for Communication Mode. LAN Group selection menu will
appear when "IP Masquerade" is selected.
LAN Group (a unit to which IP masquerade is applied)
Refer to [Sec. 6.5.5.5 Set LAN Group] for more information.
Bridge-adapted VLAN.
Packet Detect Activate, WAN Filter, VPN and/or Secondary Service are
not supported with "Bridge" mode.
Refer to [Sec. 6.5.5.6 Further Settings for User LAN] for more
information about VLAN.
Registers the Connection Mode.
1)
5)
Fig. 6.5.5.1e WAN Filter menu
6-56
3)
3)
Contents
9)
6)
7)
8)
Advertisement
Table of Contents
