Panasonic KX-TDA100 Pc Programming Manual page 702

2.12 [5] Optional Device
SVM Cyclic Tone Detection
Selects the cyclic tone detection mode. Cyclic tone detection is used to determine the end of a call
when an extension user records a greeting message or callers leave voice messages in a message
box.
To apply changes to this setting, follow the steps below:
1.
Change this setting.
2.
Set the status of the SVM card (KX-TDA30) or OPB3 card (KX-TDA100/KX-TDA200/KX-
TDA600) to "OUS", then "INS".
Value Range
Fixed: The number of times of a tone pattern (a set of tone-on and tone-off) that the PBX receives is
fixed to 4 times in the ranges of:
A
B
A B , = 100–1300 ms,
Option: The tone pattern that the PBX receives is optional as specified in SVM Cyclic Tone Option
on this screen.
Maintenance Console Location
2.12.5 [5-3-3] Voice Message—SVM
Programming Manual References
2.8.1 [1-1] Slot
Feature Guide References
1.17.8 Built-in Simplified Voice Message (SVM)
SVM Cyclic Tone Option—Tone On Maximum Time
Specifies the maximum duration of the cyclic tone that will be recognised by the PBX. When the tone
sent from the telephone company is shorter than the value set here, the PBX recognises it as a tone-
on.
Note that this option can only be set when SVM Cyclic Tone Detection on this screen is set to
"Option".
To apply changes to this setting, follow the steps below:
1.
Change this setting.
2.
Set the status of the SVM card (KX-TDA30) or OPB3 card (KX-TDA100/KX-TDA200/KX-
TDA600) to "OUS", then "INS".
Value Range
20 × n (n=6–200) ms
Maintenance Console Location
2.12.5 [5-3-3] Voice Message—SVM
702 PC Programming Manual
C C
C
D D
= A 90 ms,
C
D
= 90 ms
D B