Panasonic KX-TDA100 Pc Programming Manual page 114

2.8 [1] Configuration
T1: T-1 Trunk Card
E1: E-1 Trunk Card
E&M8: 8-Port E & M Trunk Card
DID8: 8-Port DID Card
IP-GW4 (KX-TDA0480/KX-TDA0484): 4-Channel VoIP Gateway Card
OPB3: Optional 3-Slot Base Card
CTI-LINK: CTI Link Card
IP-GW16: 16-Channel VoIP Gateway Card
IP-EXT16: 16-Channel VoIP Extension Card
EECHO16: 16-Channel Echo Canceller Card
EMPR: MPR Card
Maintenance Console Location
2.8.2 [1-1] Slot—Summary
Programming Manual References
2.8.1 [1-1] Slot
2.8.4 [1-1] Slot—Card Property - Extension Type
2.8.10 [1-1] Slot—Card Property - LCO type
2.8.13 [1-1] Slot—Card Property - BRI type/PRI type
2.8.18 [1-1] Slot—Card Property - T1 type (KX-TDA100/KX-TDA200/KX-TDA600 only)
2.8.21 [1-1] Slot—Card Property - E1 type
2.8.27 [1-1] Slot—Card Property - EM type (KX-TDA100/KX-TDA200/KX-TDA600 only)
2.8.30 [1-1] Slot—Card Property - DID type
2.8.33 [1-1] Slot—Card Property - IP Gateway
2.8.36 [1-1] Slot—Card Property - IP Extension
2.8.39 [1-1] Slot—Card Property - SIP Gateway (KX-TDA30 only)
2.8.41 [1-1] Slot—Card Property - OPB3 (KX-TDA100/KX-TDA200/KX-TDA600 only)
2.8.44 [1-1] Slot—Card Property - CTILINK (KX-TDA100/KX-TDA200/KX-TDA600 only)
2.8.45 [1-1] Slot—Card Property - DPH type (KX-TDA30 only)
Feature Guide References
None
Status
Indicates the card status (reference only).
Note that MPR card status is always displayed as "-".
Value Range
INS: The port is in service.
OUS: The port is out of service.
Fault: The port is not communicating with the network.
Pre-Install: A card has been added to the slot.
Idle: No card is installed in the slot.
114 PC Programming Manual