Panasonic KX-TDA100 Pc Programming Manual page 103

Q What settings do I change to enable use of an extension ISDN telephone?
A • From the 2.8.14 [1-1] Slot—Port Property - BRI Port screen, set the Port Type of the
port you want to use to "Extension".
Q When using a TE with an extension ISDN, how do I enable power output?
A • From the 2.8.14 [1-1] Slot—Port Property - BRI Port screen, set ISDN TE Power on
the ISDN Extension tab to "Enable".
Q How do I connect to another PBX using QSIG?
A • From the 2.8.14 [1-1] Slot—Port Property - BRI Port or 2.8.16 [1-1] Slot—Port
Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only) screen, set the Port
Type of the port you want to use to either "QSIG-Slave" or "QSIG-Master".
Q How do I change the type of an extension port?
A • Set the port to OUS status. Then, change DPT Type—Type in the 2.8.5 [1-1] Slot—Port
Property - Extension Port window.
Q I have set the type of an extension port to "DSS Console", but I cannot apply
this setting. (Error E000402)
A • The number entered in DPT Type—Location No. on the 2.8.5 [1-1] Slot—Port
Property - Extension Port screen is the same as that entered for another DSS Console.
Change this so that the numbers do not overlap.
I have set the type of an extension port to "VM (DPT)", but I cannot apply this
Q
setting. (Error E000403)
A • The DPT Type—VM Unit No. and DPT Type—VM Port No. settings entered on the 2.8.5
[1-1] Slot—Port Property - Extension Port screen are the same as those entered for
another VM (DPT). Change this so that the numbers do not overlap.
Q I have set the type of an extension port to "PC Console", but I cannot apply this
setting. (Error E000402)
A • The number entered in DPT Type—Location No. on the 2.8.5 [1-1] Slot—Port
Property - Extension Port screen is the same as that entered for another PC Console.
Change this so that the numbers do not overlap.
Q What programming do I have to perform to use a headset with an extension?
A • Set Headset OFF/ON on the 2.8.5 [1-1] Slot—Port Property - Extension Port screen
to "Headset ON".
Q What programming do I have to perform to use XDP with an extension port?
A • Set XDP Mode on the 2.8.5 [1-1] Slot—Port Property - Extension Port screen to "On".
Q How do I edit a Class of Service, or create a new Class of Service?
A • Class of Service feature restrictions can be set from the 2.9.11 [2-7-1] Class of
Service—COS Settings screen.
Q How do I restrict calls between 2 extensions?
2.7 Help
PC Programming Manual 103