Ars Mode - Panasonic KX-TDA100 Pc Programming Manual

2.13 [6] Feature

ARS Mode

Specifies the ARS mode used when making a trunk call.
Value Range
Off: ARS is disabled.
On for Local Access Operation: ARS operates when an extension user makes a call using any Idle
Line Access method.
On for Any CO Access Operation: ARS operates when an extension user makes a call using any
Trunk Access method.
Same as System Setting: The setting specified in ARS Mode in 2.15.1 [8-1] System Setting is
applied.
Maintenance Console Location
2.13.6 [6-6] Tenant
Programming Manual References
2.15.1 [8-1] System Setting
Feature Guide References
1.10.1 Automatic Route Selection (ARS)
2.2.3 Tenant Service
System Speed Dial
Specifies which system speed dialling table is used by the tenant. This setting is only available when
an MEC (KX-TDA30/KX-TDA100/KX-TDA200) or EMEC (KX-TDA600) card is installed.
Value Range
For KX-TDA30:
Basic Memory: PBX basic system speed dialling numbers are used.
Expanded Memory: Expansion system speed dialling numbers are used.
For KX-TDA100/KX-TDA200/KX-TDA600:
Same as System Setting: PBX common system speed dialling numbers are used.
Tenant Exclusive: Individual tenant system speed dialling numbers are used.
Maintenance Console Location
2.13.6 [6-6] Tenant
Programming Manual References
2.13.1 [6-1] System Speed Dial
Feature Guide References
1.6.1.5 Speed Dialling—Personal/System
2.2.3 Tenant Service
728 PC Programming Manual