2.1.4
Card Status
Certain tools, utilities and settings require that the target card be set to out-of-service (OUS) or in-
service (INS) status before the operation is carried out. Where required, this is noted in the
description of each item. Card status changes can only be performed when the software is in
Interactive mode (see 2.1.1 Starting Maintenance Console and Software Modes).
•
"In service" means that the card is installed correctly in the PBX, and is capable of being
used normally.
•
"Out of service" means that the card is installed correctly in the PBX, but has been
temporarily removed from use. This allows settings to be modified or software to be
upgraded.
•
"Fault" means that the card is not installed in the PBX correctly, or is not functioning correctly.
For more information, see the Installation Manual.
For details about how to change the status of a card, see To change the status (INS/OUS) of a card
(Interactive mode only) on screen 2.8.1 [1-1] Slot.
2.1 Introduction
PC Programming Manual
35