Panasonic KX-TDA100 Pc Programming Manual page 266

2.8 [1] Configuration
Feature Guide References
1.5.4.4 Dial Type Selection
1.22.1 E1 Line Service
E1 Receiver Type
Selects the type of signal the PBX receives from the E1 line.
This should be set to MFC-R2 when receiving ANI (Automatic Number Identification) numbers from
the E1 line.
Value Range
DTMF, Pulse, MFC-R2, Undefined
Maintenance Console Location
2.8.25 [1-1] Slot—Port Property - E1 Port
Programming Manual References
None
Feature Guide References
1.22.1 E1 Line Service
Receive Digits
Specifies the maximum number of digits to be received from a DDI/DID number when receiving a call
with the DDI/DID number.
Value Range
0–15
Maintenance Console Location
2.8.25 [1-1] Slot—Port Property - E1 Port
Programming Manual References
None
Feature Guide References
None
CPC Detection Time—Out, In
Specifies the length of time required by the PBX to detect a CPC signal on outgoing or incoming trunk
calls before disconnecting the line. When None is selected here, the line will not be disconnected
when a CPC signal is not detected.
Value Range
None, 80 × n (n=2–75) ms
266 PC Programming Manual