Panasonic KX-TDA100 Pc Programming Manual page 150

2.8 [1] Configuration
Maintenance Console Location
2.8.11 [1-1] Slot—Port Property - LCO Port
Programming Manual References
None
Feature Guide References
1.5.4.4 Dial Type Selection
CPC Signal Detection Time—Outgoing, Incoming
Specifies the length of time required by the PBX to detect a CPC signal on outgoing or incoming trunk
calls before disconnecting the line. When None is selected here, the line will not be disconnected
when a CPC signal is not detected.
Value Range
None, 6.5 ms, 8 × n (n=1–112) ms
Maintenance Console Location
2.8.11 [1-1] Slot—Port Property - LCO Port
Programming Manual References
None
Feature Guide References
1.11.10 Calling Party Control (CPC) Signal Detection
DTMF Width
Selects the length of the DTMF tone sent to the analogue trunk.
Value Range
80 ms, 160 ms
Maintenance Console Location
2.8.11 [1-1] Slot—Port Property - LCO Port
Programming Manual References
None
Feature Guide References
None
Pulse Speed
Selects the speed at which pulse dials are sent to the analogue trunk.
150 PC Programming Manual