Hood; Front Fenders - Arctic Cat HDX CREW 2017 Service Manual

2. From under the hood, install the two cap screws
securing the bottom of the front storage box to the
front bumper. Using the previously marked harness
anchor locations, install the anchors to the front
bumper.
3. Secure the radiator to the front bumper and connect
the radiator fan to the wiring harness.
4. Install both headlight assemblies onto the front
bumper and secure with the retaining clips. Install
the headlight adjuster screws.
HDX304
HDX305A
5. Secure the lower front fascia to the frame followed
by the upper front fascia.
HDX303A
28
HDX302A
6. Install the inner then outer front fenders to the vehi-
cle. Place the front access panel into position and
secure with the plastic push pins. Install the access
cover seal.
7. Check and adjust headlight aim (see Headlight - Tail-
light/ Brakelight section).

Hood

REMOVING
1. Open the hood; then remove the four cap screws
securing the hood hinges to the frame.
PR902A
2. Remove the hood assembly.
CLEANING AND INSPECTING
1. Clean all hood components with soap and water.
2. Inspect the hood for cracks and/or loose fasteners.
3. Inspect for any missing decals.
INSTALLING
Place the hood into position on the vehicle; then secure
with the cap screws. Tighten securely.

Front Fenders

REMOVING
1. Remove the four cap screws securing each outer
fender to the corresponding inner fender; then
remove the fenders.