Rear A-Arms - Arctic Cat HDX 700 2017 Service Manual

HDX387
8. Apply grease to the hub and drive axle splines; then
install the hub (see Drive System).
PR290A
9. Secure the brake caliper holder to the knuckle with
two new "patch-lock" cap screws. Tighten to 20 ft-
lb.
PR377B
10. Install the wheels and using a crisscross pattern,
tighten the wheel nuts in 20 ft-lb increments to a final
torque of 40 ft-lb (steel wheel), 60 ft-lb (aluminum
wheel w/black nuts), or 80 ft-lb (aluminum wheel w/
chrome nuts).
11. Remove the vehicle from the support stand.
184

Rear A-Arms

REMOVING
1. With the vehicle in park, secure the vehicle on a sup-
port stand to elevate the wheels.
! WARNING
Make sure the vehicle is solidly supported on the sup-
port stand to avoid injury.
2. Remove the wheel.
3. Secure a strap to the top of the rear knuckle and
frame. This will support the knuckle and axle while
the A-arms are being removed.
4. Remove the cap screws securing the boot guard to
the lower A-arm.
5. Loosen and remove the sway bar link lock nut and
cap screw. Account for bushings, washers, and
spacer.
PR922
6. Remove the cap screws and lock nuts securing the
shock absorber to the frame and lower A-arm; then
remove the shock absorber. Discard the lock nuts.
500
PR923A