Resetting the KX II Using the Reset Button
Modifying Scripts
To modify existing scripts:
1. Click Device Settings > Connection Scripts. The Connection Scripts
page opens.
2. In the Available Connection Scripts section, select the script you
want to modify and click Modify. The page is then in Edit mode.
3. Make changes as needed. Click OK when finished.
On the back panel of the device, there is a Reset button. It is recessed to
prevent accidental resets (you need a pointed object to press this
button). The actions that are performed when the Reset button is
pressed are defined on the Encryption & Share page. See
Share
(on page 219).
Note: It is recommended that you save the audit log prior to performing a
factory reset. The audit log is deleted when a factory reset is performed
and the reset event is not logged on the audit log. For more information
about saving the audit log, see
To reset the device:
1. Power off the KX II.
2. Use a pointed object to press and hold the Reset button.
3. While continuing to hold the Reset button, power the KX II device
back on.
4. Continue holding the Reset button for 10 seconds. Once the device
has been reset, two short beeps signal its completion.
Chapter 13: KX II Local Console
Audit Log
(on page 230).
Encryption &
281