Upgrade History - Raritan Dominion KX II User Manual

Upgrade History

As prompted, close the browser and wait approximately 5 minutes before
logging in to the KX II again. again. For information about upgrading the
device firmware using the Multi-Platform Client, see Upgrading Device
Firmware in the KVM and Serial Access Clients Guide.
Note: Firmware upgrades are not supported via modem.
Note: If you are using a tiered configuration in which a base KX II device
is used to access multiple other tiered devices, you may receive a low
memory error during a firmware upgrade if you have a large number of
user groups. If you receive this error, reboot the device and then perform
the upgrade again. If you continue to receive this error after rebooting,
disable tiering on the base device and perform the upgrade again.
Note: When upgrading firmware, the active certificate and CSR are not
replaced.
The KX II provides information about upgrades performed on the KX II
and attached CIMS.
To view the upgrade history:

Choose Maintenance > Upgrade History. The Upgrade History page
opens.
Information is provided about the KX II upgrade(s) that have been run,
the final status of the upgrade, the start and end times, and the previous
and current firmware versions. Information is also provided about the
CIMS, which can be obtained by clicking the show link for an upgrade.
The CIM information provided is:

Type - The type of CIM

Port - The port where the CIM is connected

User - The user who performed the upgrade

IP - IP address firmware location

Start Time - Start time of the upgrade

End Time - end time of the upgrade

Previous Version - Previous CIM firmware version

Upgrade Version - Current CIM firmware version

CIMs - Upgraded CIMs

Result - The result of the upgrade (success or fail)
Chapter 10: Maintenance
239