Raritan Dominion KX II User Manual page 45

Chapter 2: Installation and Configuration
36
Specifying Power Supply Autodetection
The KX II provides dual power supplies and can automatically detect and
provide notification regarding the status of these power supplies. Proper
configuration ensures that the KX II sends the appropriate notifications
should a power supply fail.
The Power Supply Setup page is configured to automatically detect both
power supplies when two power supplies are used. If only one power
supply is used in your configuration, you can disable automatic detection
from the Power Supply Setup page.
To enable automatic detection for the power supplies in use:
1. Choose Device Settings > Power Supply Setup. The Power Supply
Setup page opens.
2. If you are plugging power input into power supply number one (left-
most power supply at the back of the device), select the Powerln1
Auto Detect option.
3. If you are plugging power input into power supply number two (right-
most power supply at the back of the device), select the Powerln2
Auto Detect option.
4. Click OK.
Note: If either of these checkboxes is selected and power input is not
actually connected, the power LED at the front of the device turns red.
To disable power supply autodetection for the power supply not
in use:
1. Using the KX II Local Console, choose Device Settings > Power
Supply Setup. The Power Supply Setup page opens.
2. Clear autodetection for the power supply that you are not using.
For more information, see
Note to CC-SG Users
If you are using the KX II in a CC-SG configuration, perform the
installation steps, and when finished, consult the CommandCenter
Secure Gateway User Guide, Administrator Guide, or Deployment
Guide to proceed (all found on Raritan's website, www.raritan.com,
under Support).
Note: The remainder of this help applies primarily to deploying the KX II
device(s) without the integration functionality of CC-SG.
Power Supply Setup (on page 167).