Chapter 13: KX II Local Console
276
KX II Local Console Factory Reset
Note: This feature is available only on the KX II Local Console.
The KX II offers several types of reset modes from the Local Console
user interface.
Note: It is recommended that you save the audit log prior to performing a
factory reset. The audit log is deleted when a factory reset is performed
and the reset event is not logged in the audit log. For more information
about saving the audit log, see Audit Log (on page 230).
To perform a factory reset:
1. Choose Maintenance > Factory Reset. The Factory Reset page
opens.
2. Choose the appropriate reset option from the following options:
Full Factory Reset - Removes the entire configuration and resets
the device completely to the factory defaults. Note that any
management associations with CommandCenter will be broken.
Because of the complete nature of this reset, you will be
prompted to confirm the factory reset.
Network Parameter Reset - Resets the network parameters of
the device back to the default values (click Device Settings >
Network Settings to access this information):
IP auto configuration
IP address
Subnet mask
Gateway IP address
Primary DNS server IP address
Secondary DNS server IP address
Discovery port
Bandwidth limit
LAN interface speed & duplex
Enable automatic failover
Ping interval (seconds)
Timeout (seconds)
3. Click Reset to continue. You will be prompted to confirm the factory
reset because all network settings will be permanently lost.
4. Click OK proceed. Upon completion, the KX II device is automatically
restarted.