Selecting Profiles For A Kvm Port - Raritan Dominion KX II User Manual

Selecting Profiles for a KVM Port

USB profile
Use Full Speed for Virtual
Media CIM
The KX II comes with a set of USB profiles that you can assign to a KVM
port based on the characteristics of the KVM target server it connects to.
You assign USB profiles to a KVM port in the Device Settings > Port
Configuration > Port page in either the KX II Remote or Local Console.
It is the administrator that designates the profiles that are most likely to
be needed for a specific target. These profiles are then available for
selection via MPC, AKC and VKC. If a profile has not been made
available, you can access any of the available profiles by selecting USB
Profile > Other Profiles.
Assigning USB profiles to a KVM port makes those profiles available to a
user when connected to a KVM target server. If required, the user can
select a USB profile from the USB Profile menu in VKC, AKC or MPC.
For information about assigning USB profiles to a KVM port, see
Configuring USB Profiles (Port Page)
Chapter 6: USB Profiles
Description

Virtual CD-ROM and disk drives
cannot be used simultaneously
WARNING: USB enumeration will
trigger whenever virtual media is
connected or disconnected.
Use Full Speed for virtual media CIM
This profile resembles the behavior of
the original KX2 release with Full
Speed for virtual media CIM option
checked. Useful for BIOS that cannot
handle High Speed USB devices.
Restrictions:

USB bus speed limited to full-
speed (12 MBit/s)
(on page 198).
117