Raritan Dominion KX II User Manual page 206

Blade chassis Required/recommended action
done.

Do not designate any slots for scan operations in the iKVM GUI
Setup Scan menu or the iKVM may not work properly.

To avoid having the iKVM GUI display upon connecting to the
blade chassis, set the Screen Delay Time to 8 seconds.

Recommend that 'Timed' and 'Displayed' be selected during
iKVM GUI Flag Setup. This will allow you to visually confirm
the connection to the desired blade slot.

® ® It is recommended that Auto-Discovery be enabled when
IBM /Dell Auto-
Discovery applying blade level access permissions. Otherwise, set access
permissions on a blade-chassis wide basis.

Secure Shell (SSH) must be enabled on the blade chassis
management module.

The SSH port configured on the blade chassis management
module and the port number entered on the Port Configuration
page must match.

Raritan KX II virtual media is supported only on IBM
IBM KX2 Virtual
Media BladeCenter
D2CIM-DVUSB. The black D2CIM-DVUSB Low-Speed USB
connector is attached to the Administrative Management
Module (AMM) at the rear of the unit. The gray D2CIM-DVUSB
High-Speed USB connector is attached to the Media Tray (MT)
at the front of the unit. This will require a USB extension cable.
Note: All IBM BladeCenters that use AMM must use AMM firmware
version BPET36K or later to work with the KX II.
Note: In the case of IBM Blade Center Models E and H, the KX II only
supports auto-discovery for AMM[1] as the acting primary management
module.
Blade Chassis Sample URL Formats
This table contains sample URL formats for blade chassis being
configured in the KX II.
Blade chassis Sample URL format

Dell ® M1000e URL: https://192.168.60.44/cgi-bin/webcgi/login

Username: root

Username Field: user

Password: calvin

Password Field: password

URL: https://192.168.60.33/Forms/f_login
Dell 1855
Chapter 8: Device Management
®
Models H and E. This requires the use of the
197