Raritan Dominion KX II User Manual page 43

Chapter 2: Installation and Configuration
34
Enter the following information if the Following DNS Server
Addresses option is selected. These addresses are the primary and
secondary DNS addresses that will be used if the primary DNS
server connection is lost due to an outage.
a. Primary DNS Server IP Address
b. Secondary DNS Server IP Address
7. When finished, click OK.
See LAN Interface Settings
this section of the Network Settings page.
Note: In some environments, the default LAN Interface Speed & Duplex
setting Autodetect (autonegotiator) does not properly set the network
parameters, which results in network issues. In these instances, setting
the KX II LAN Interface Speed & Duplex field to 100 Mbps/Full Duplex
(or whatever option is appropriate to your network) addresses the issue.
See the Network Settings
Configure Date/Time Settings (Optional)
Optionally, configure the date and time settings. Note that date and time
settings impact SSL certificate validation if LDAPS is enabled.
To set the date and time:
1. Choose Device Settings > Date/Time. The Date/Time Settings page
opens.
2. Choose your time zone from the Time Zone drop-down list.
3. To adjust for daylight savings time, check the "Adjust for daylight
savings time" checkbox.
4. Choose the method you would like to use to set the date and time:

User Specified Time - Choose this option to input the date and
time manually. For the User Specified Time option, enter the
date and time. For the time, use the hh:mm format (using a 24-
hour clock).

Synchronize with NTP Server - Choose this option to synchronize
the date and time with the Network Time Protocol (NTP) Server.
5. For the Synchronize with NTP Server option:
a. Enter the IP address of the Primary Time server.
b. Enter the IP address of the Secondary Time server. Optional
6. Click OK.
(on page 148) for information in configuring
(on page 145) page for more information.