Raritan Dominion KX II User Manual page 293

Appendix A: Using KX II to Access Paragon II
Connecting the Paragon II to the KX II
284
The user station with DCIM-USB-G2 or DCIM-PS2
attached
KX II
When you access the Paragon system from KX II or CC-SG (if the KX II
is managed by CC-SG), the Paragon OSUI login screen appears for you
to log in.
In this integration, you can perform any OSUI functions implemented with
current Paragon firmware or any KX II function implemented with current
KX II firmware except for the virtual media feature.
When accessing the Paragon OSUI through KX II, DO NOT attempt to
synchronize the mouse manually. A mouse is not necessary on the OSUI
screen and mouse synchronization will delay the keyboard response for
seconds.
See Supported Paragon CIMS and Configurations
additional information.
To connect the Paragon II system to KX II:
1. Check whether the user station that you want to connect to KX II is
implemented with version 4.6 firmware or later. If not, upgrade it. See
Firmware Upgrade for upgrade instructions. The user station can be
one of these:

P2-UST

P2-EUST

P2-EUST/C
2. Connect a compatible DCIM to this user station. If the system is a
two- or three-tier system, ensure the user station is one of those
connected to the Base Unit (first tier).
Only two types of DCIMs are supported in this integration:

If using DCIM-USB-G2, plug its connectors into the USB and
video ports on the user station.

If using DCIM-PS2, plug its connectors into the PS/2 and video
ports on the user station.
3. Connect the user station to a KX II device via a Cat5 UTP cable up
to 150 feet (45 m).

Plug one end of the cable to the DCIM's RJ-45 port and the other
end to one of the channel ports on the KX II device.
(on page 290) for