Raritan Dominion KX II User Manual page 204

Blade chassis Connection method
Technology
IBM BladeCenter E The current model BladeCenter E chassis
(8677-3Rx) ships standard with one Advanced
Management Module.
Source: IBM BladeCenter Products and
Technology
IBM BladeCenter T The BladeCenter T chassis ships standard with
one Advanced Management Module.
In contrast to the standard BladeCenter
chassis, the KVM module and the
Management Module in the BladeCenter T
chassis are separate components. The front of
the Management Module only features the
LEDs for displaying status. All Ethernet and
KVM connections are fed through to the rear to
the LAN and KVM modules.
The KVM module is a hot swap module at the
rear of the chassis providing two PS/2
connectors for keyboard and mouse, a
systems-status panel, and a HD-15 video
connector.
Source: IBM BladeCenter Products and
Technology
IBM BladeCenter HT The BladeCenter HT chassis ships standard
with one Advanced Management Module. This
module provides the ability to manage the
chassis as well as providing the local KVM
function.
Source: IBM BladeCenter Products and
Technology
Note: In order to support Auto-discovery, IBM BladeCenter Models H and
E must use AMM with firmware version BPET36K or later.
Note: In the case of IBM Blade Center Models E and H, the KX II only
supports auto-discovery for AMM[1] as the acting primary management
module.
Note: Audio is disabled for all KVM switch targets.
Chapter 8: Device Management
Recommended CIM(s)

DCIM-USBG2

D2CIM-DVUSB

DCIM-PS2

DCIM-USBG2
195