Rename the port. When a CIM is attached the CIM name will
be used.
Rename the port, and select 'Persist name on Next CIM
Insertion'. When a CIM is attached the name that has been
assigned will be copied into the CIM.
Reset the port, including the name, to factory defaults by
selecting 'Reset to Defaults'. When a CIM is attached the
CIM name will be used.
Note: Do not use apostrophes for the Port (CIM) Name.
Port Type:
DCIM - Dominion CIM
Not Available - No CIM connected
MCUTP - Master Console MCUTP, CIM in a cable
PCIM - Paragon CIM
PowerStrip (rack PDU) - Power strip connected
Dual - VM - Virtual media CIM (D2CIM-VUSB and D2CIM-
DVUSB)
Blade Chassis - Blade chassis and the blades associated
with that chassis (displayed in a hierarchical order)
KVM Switch - Generic KVM Switch connection
2. Click the Port Name for the port you want to edit.
For KVM ports, the Port page for KVM and blade chassis ports is
opened.
For rack PDUs, the Port page for rack PDUs (power strips) is
opened. From this page, you can name the rack PDUs and their
outlets.
Configuring Standard Target Servers
To name the target servers:
1. Connect all of the target servers if you have not already done so.
See
Step 3: Connect the Equipment
of connecting the equipment.
2. Choose Device Settings > Port Configuration. The Port Configuration
page opens.
3. Click the Port Name of the target server you want to rename. The
Port Page opens.
4. Select Standard KVM Port as the subtype for the port.
Chapter 8: Device Management
(on page 28) for a description
169