Error Code - Fuji Xerox ApeosPort-II C7500 Administrator's Manual

Error Code

This section explains error codes.
If an error caused printing to end abnormally, or a malfunction occurred in the machine,
then an error message code (∗∗∗-∗∗∗) is displayed.
Refer to the following table for error codes to rectify problems.
Important • If an error code is displayed, any print data remaining on the machine and information stored
If an error code appears that is not listed in the table below, or if an error persists after
following the listed solution, contact our Customer Support Center. The contact number
is printed on the label or card attached on the machine.
Errors are classified into the following categories.
C: Copy
P: Print
S: Scan
M: Mail
O: Others
Category

Error Code

C P S M O
002-770
O
003-701 O O
003-702
O O
003-750 O
003-751 O O
003-752 O
003-753 O
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
in the machine's memory is not warranted.
O [Cause] Unable to process the job template due to insufficient hard
disk space.
[Remedy] Remove unnecessary data from the hard disk to increase free
disk space.
[Cause] A digital code is embedded in the document to restrict
duplication.
[Remedy] Use a document that no digital code is embedded in.
[Cause] When making 2-Sided copies using Build Job feature, a ratio
does not match of the front side and the back side.
[Remedy] Make sure to match the ratio of the front side and the back
side.
[Cause] Unable to store any documents using the 2-Sided Book Copy
feature.
[Remedy] Check the 2-Sided Book Copy settings.
Refer to "3 Copy" > "Layout Adjustment" > "2 Sided Book Copy (Making 2
Sided Copies of Facing Pages)" in the User Guide.
[Cause] Unable to process, because the specified document area is
too small.
[Remedy] Increase the resolution or scan area.
[Cause] The mixed sized document was to be scanned at 600dpi with
Color/2 Sided.
[Remedy] Set [Scan Resolution] to [400dpi] or lower, and try again.
[Cause] The mixed sized document was to be scanned with high
resolution using the 2-sided feature.
[Remedy] Set [Scan Resolution] to [200dpi], and try again.
Cause and Remedy
Error Code
14
323