Installation Procedure; Installation Overview; Enabling Port And Setting Tcp/Ip - Fuji Xerox ApeosPort-II C7500 Administrator's Manual

Installation Procedure

Installation Overview

This section describes the configuration procedure to use the E-mail feature on the
machine.
The following two steps are necessary to use the E-mail feature.

Enabling port and setting TCP/IP

Set the machine to be able to use TCP/IP.
Configuring E-mail Environment
Set the items for e-mail on the machine.
Enabling Port and Setting TCP/IP
The following describes the configuration procedure to use TCP/IP on the machine.
First enable the E-mail port, then set the IP address.
Note
For the items that can be configured using CentreWare Internet Services, refer to "Using CentreWare
Internet Services" (P.211).
1
Display the [System Settings] screen.
1) Press the <Log In/Out> button.
2) Enter the user ID with the numeric keypad or a keyboard displayed by pressing
[Keyboard], and select [Confirm].
Note
3) Select [System Settings].
4) Select [System Settings].
2
Enable a port which is used for the E-mail feature.
1) Select [Network Settings].
2) Select [Port Settings].
3) Select [Send E-mail], and then select [Change Settings].
4) Select [Port Status], and select [Change Settings].
5) Select [Enabled], then select [Save].
6) Select [Close].
7) Enable [Receive E-Mail] in the [Receive E-mail - Port Status] screen as above to
use E-mail Printing.
8) Enable [Mail Notice Service] in the [Mail Notice Service - Port Status] screen as
above to use mail notice or job completion notice.
9) Select [Close] repeatedly until the [Network Settings] screen is displayed.
3
Set an IP address.
If an IP address is already set, this step is not necessary. Also, in an environment with
DHCP or BOOTP, configure the way to obtain an IP address. Either the address
cannot be obtained automatically or manual configuration is preferred, configure an IP
address, a subnet mask, and a gateway address.
• The configuration can also be performed using CentreWare Internet Services.
• The default user ID is "11111". When using the Authentication feature, a passcode is
required. The default passcode is "x-admin".
Installation Procedure
241
9