Configuring/Canceling The Auto Link Server - Fuji Xerox ApeosPort-II C7500 Administrator's Manual

Yes
Allows you to enter a user ID and password into [User ID] and [Password] respectively, which
are used when the machine accesses the remote service.
User ID
Enter the User ID to access the remote service, with up to 128 characters.
Important • Depending on the settings on the remote service, the entry for [User ID] may be invalid.
Note
Password
Enter the password for the User ID, with up to 128 characters.
Machine/Authentication Notification
Set whether to notify the remote server of machine information and user authentication
information every time the machine is connected to the remote service.
Note
Reset Account
Deletes all settings registered.

Configuring/Canceling the Auto Link Server

The auto link server is a server to be connected automatically when activating the Web
Applications.
To configure or cancel the auto link server, follow the procedure below.
1
Select the access destination you want to set as the auto link server.
2
To configure the settings, select [Enter].
To cancel the settings, select [Clear].
Auto Link Server No
The number of the server set as the auto link server appears.
Web Applications Settings for ApeosPort Series Models Only
Check the settings on the remote service.
• Along with [User ID], set also [Password]. [User ID] will be invalid unless [Password] is set.
• All the specified settings are ignored if the remote service to be connected requires other
than a user ID and its password for authentication.
• The remote service determines whether to use the information. No need to configure
settings on the control panel.
6
187