Fuji Xerox ApeosPort-II C7500 Administrator's Manual page 250

10 Scanner Environment Settings
4) Select [Port Status] and select [Change Settings].
5) Select [Enabled] then select [Save].
6) Select [Close] repeatedly until the [Network Settings] screen is displayed.
1) Select [Network Settings].
2) Select [Port Settings].
3) Select [WebDAV] and then select [Change Settings].
4) Select [Port Status] and select [Change Settings].
5) Select [Enabled] then select [Save].
6) Select [Close] repeatedly until the [Port Settings] screen is displayed.
7) Enable [Internet Services (HTTP)] in the [Internet Services - Port Status] screen as
8) Select [Close] repeatedly until the [Network Settings] screen is displayed.
3
Set an IP address.
If an IP address is already set, this step is not necessary. Also, in an environment with
DHCP or BOOTP, configure the way to obtain an IP address. Either the address
cannot be obtained automatically or manual configuration is preferred, configure an IP
address, a subnet mask, and a gateway address.
For information on how to set an IP address, refer to "Starting CentreWare Internet Services".
4
Select [Close] repeatedly until the [System Settings] screen is displayed.
5
Select [Exit].
6
After the machine is restarted, print out a settings list to confirm that the salutation or
WebDAV port and the Internet Services (HTTP) port are enabled and the IP
addresses are configured.
For information on how to print a settings list, refer to "Print Report/List" (P.97).
10
248
When using an application supporting a WebDAV protocol provided by Fuji Xerox
such as CentreWare EasyOperator
above.