Fuji Xerox ApeosPort-II C7500 Administrator's Manual page 209

PJL Receive Command Control
Print jobs submitted by external equipment can be controlled by PJL commands. The settings
for [Receive Control] described later are applied when either [Off] is selected or no PJL
command is received.
PJL Output Command Control
Print jobs submitted by an external equipment can be controlled by PJL commands.
Receive Control
You can set how received print jobs should be handled.
For information about printing from a print driver, refer to "7 Computer Operations" >"Printing" in the
User Guide (DocuCentre series models) or "9 Computer Operations" > "Printing" in the User Guide
(ApeosPort series models).
For information about printing or deleting the print job that are saved after being received, refer to
"Private Charge Print" (P.81) and "Charge Print" (P.79).
1
Select [Receive Control], and select [Change Settings].
2
Select any item.
3
According to the selected item, set
the processing to be applied to
jobs.
According to Print Auditron
Follows the settings for the [Printer
Settings] under "Login Setup/Auditron
Mode" (P.209) and "Auditron Mode"
(P.210).
Note • To restrict print job operations
When [According to Print Auditron] is selected, [Job Login Success], [Job Login Failure] and
[Job without User ID] appear.
Job Login Success
Set the processing to be applied to successfully authenticated jobs.
- To print all received jobs, select [Print Job].
- To save received jobs using the Private Charge Print feature, select [Save in Private
Charge Print].
Note • When [Save in Private Charge Print] is selected, the Security Print, Sample Print, Mailbox
• When saving the print jobs in Private Charge Print, use up to 24 characters for the User ID.
Job Login Failure
Set the processing to be applied to authentication failure jobs (whose information, such as
the user ID and passcode, has been incorrectly registered on the print driver).
- When [Save in Charge Print] is selected, all jobs received are saved.
- When [Cancel Job] is selected, jobs received are deleted.
Job without User ID
Set the processing to be applied to jobs with no user ID attached (such as print or e-mail print
jobs sent from CentreWare Internet Services).
- To print all jobs, select [Print Job].
- To save jobs using the Charge Print feature, select [Save in Charge Print].
- To delete jobs, select [Cancel Job].
using the authentication
feature, set [Login/Setup
Auditron Mode] to [Local Machine Access] or [Network Access], and also set [Printer] under
[Auditron Mode] to [On].
Print, and Delayed Print settings specified on the print driver will be ignored.
If the User ID set on the print driver exceeds 24 characters, a print job will be cancelled, and
will not be saved in Private Charge Print.
Login Setup/Auditron Administration
6
207