Table of Contents
Advertisement
Category
Error Code
C P S M O
016-751
O
016-752
O
016-753
O
016-755
O
016-756
016-757
016-758
O O O
016-759
O O O
016-760
O
016-761
O
016-762
O
016-763
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
[Cause]
1. During the PDF Bridge processing, one of the following
occurred: a syntax or parameter error occurred; an
undefined command was used; and a PDF file was
damaged.
2. When [Print Processing Mode] for the PDF Direct Print
feature has been set to [PS]: Cause 1 or insufficient
memory.
[Remedy] For Cause 1: Use the print driver to print the document.
For Cause 2: Take one of the following actions:
Use the print driver to print the document.
Expand the PostScript memory.
For information on the memory, refer to "Allocate Memory" (P.169).
[Cause]
Unable to process for PDF Bridge due to insufficient memory
space.
[Remedy] Change the [Print Mode] setting from [High Image Quality] to
[Normal], or from [Normal] to [High Speed]. Or, add memory.
[Cause]
The entered password does not agree with that of the PDF file.
[Remedy] Set the correct password on ContentsBridge.
[Cause]
Attempted to process a print protected PDF file.
[Remedy] Cancel the print protection using Adobe Reader, and try to
print again.
O [Cause]
No permissions to use the service.
[Remedy] Check with your System Administrator.
O [Cause]
The password is incorrect.
[Remedy] Enter the correct password.
[Cause]
No permissions to use the service.
[Remedy] Check with your Auditron Administrator.
[Cause]
The number of pages reached the maximum number of pages
for this service.
[Remedy] Check with your Auditron Administrator.
[Cause]
An error occurred during processing with Adobe PostScript 3
Kit (optional).
[Remedy] Take one of the following actions:
Set [Print Mode] to [Normal].
Expand PostScript memory.
For information about [Print Mode], refer to the print driver's online help. For
information about memory, refer to "Allocate Memory" (P.169).
[Cause]
An error occurred during image processing.
[Remedy] Set [Print Mode] to [Normal] and try again. If the problem
persists, set [Page Print Mode] to [On].
[Cause]
The specified print language is not installed on the machine.
[Remedy] In [Specify Print Mode] under [Port Settings], specify another
print language.
O
[Cause]
Connection error to the POP server
[Remedy] Check if the IP address of the POP server is correctly set on
the machine.
Cause and Remedy
Error Code
14
337
Advertisement
Chapters
Table of Contents
