MUTOH ValueJet VJ-1204 Operation Manual page 29

VJ-1204 OPERATION MANUAL
2. Connect the power cable to the AC inlet on the back of the printer.
No.
1
2
3. Insert the power cable plug firmly in the socket.
WARNING
• Do not take out or insert the power plug with a wet hand. This could lead to an
electric shock.
• Make sure to use only the specified power supply (AC 100 V - 120 V or AC 220 V
- 240 V). If a power supply other than the specified voltage is used, it could cause
an electric shock and fire.
• Take power for the printer directly from the power socket (AC 100 V - 120 V or AC
220 V - 240 V). Do not use multiple plugs on the same socket. This could
generate heat and might cause fire.
• Make sure to use a dedicated power socket with an earth terminal for the power
supply, and connect it to an earth terminal. If the earth wire is not connected, an
electric shock or fire may occur.
• Do not connect an earth wire to the following places.
• Gas pipe
There is a possibility of ignition and explosion.
• Earth wire of telephone cables and lightning rods
Heavy current might flow whenever lightning strikes.
• Water pipe and faucet
The earth might not work if a plastic pipe is connected in the middle of the
metal pipe.
AC inlet
Power cable
Name
3-3
3 Before using
1
2