MUTOH ValueJet VJ-1204 Operation Manual page 159

VJ-1204 OPERATION MANUAL
(2) The printing position is incorrect (some parts of the media cannot be printed
on)
No. Possible cause
1 Is the loading position of the media
correct?
2 Did you set up the origin and print
position?
(3) Printing is blurred
No. Possible cause
1 Are you using the recommended
media?
2 Are you using the thick or thin media? Use the recommended media.
3 Is the media printed on the printing
surface?
4 Did you perform Alignment?
5 Did you perform Media feed
compensation?
6 Is each heater set to the appropriate
temperature?
7 Is the head height set to High?
(4) White or black lines appear on printed media
No. Possible cause
1 Are you using the recommended
media?
2 Is the scroller set correctly?
3 Is the nozzle in good condition?
4 Did you perform Alignment?
5 Did you perform Media feed
compensation?
6 Is each heater set to the appropriate
temperature?
7 Is the head height set to High?
Remedy
Set the media correctly.
Cancel or reset the settings of the origin and
print position.
Remedy
Use the recommended media.
Confirm the printing surface of the media
and set it correctly.
Perform Alignment.
Perform Media feed compensation.
Set it to the appropriate temperature.
Return the head height to "Normal (Low)".
Remedy
Use the recommended media.
Set the scroller correctly.
Perform Head cleaning.
Perform Alignment.
Perform Media feed compensation.
Set it to the appropriate temperature.
Return the head height to "Normal (Low)".
7-7
7 Troubleshooting
Reference
3.4.2 Setting roll
media
5 Panel setup
menu
Reference
4.2.1 Media type
4.2.1 Media type
3.4 Setting
media
3.6 Adjust print
4.2.6 Media feed
compensation
5.1.1.1.3 Pre
Heater menu to
5.1.1.1.5 After Heater
menu
4.2.5 Head
height adjustment
Reference
4.2.1 Media type
3.4.1 Loading
roll media
6.2.3 Head
cleaning
3.6 Adjust print
4.2.6 Media feed
compensation
5.1.1.1.3 Pre
Heater menu to
5.1.1.1.5 After Heater
menu
4.2.5 Head
height adjustment