MUTOH ValueJet VJ-1204 Operation Manual page 15

VJ-1204 OPERATION MANUAL 1 Safety instructions
When unpacking and moving the printer to an installation point, be sure to have the following
number of personnel.
• VJ-1204: three or more
When taking this printer out of the package box, make sure to remove the vinyl sheet and hold the
handles on the side of the printer. If the printer is lifted with the vinyl sheet attached, there is a
possibility that the printer falls slipping from hands and gets damaged.
When installing the stand to the printer, make sure to have the following number of personnel.
• VJ-1204: three or more
While installing the stand, be sure to turn OFF the power and pull out the power plug. It could lead
to an electric shock.
When you do not use the printer for a long period, make sure to pull out the power plug from the
power socket for safety.
Make sure to connect an earth wire to the earth connection that meets the following standards.
• Earth terminal of power socket
• Earth wire with copper plate which is buried at 650 mm or more, deep in the ground.
Load roll media on an even surface such as a desk. If you load roll media with the scroller standing
vertical, there is a possibility that the scroller might get damaged.
Keep the work area well-ventilated. This prevents fire, and stops operators from feeling sick from
bad air.
When printing is finished, the media guide is at high temperature. Wait until the media guide cools
off.
Pay attention to the following points when you cut roll media. Mishandling the razor blade may
cause a cut on your finger or hand.
• When you hold media, do not place your finger on the media cut groove.
• Move the razor blade along the media cut groove.
When cleaning the printer, be sure to turn OFF the power and disconnect the power plug.
Move the printer maintaining a horizontal position.
1-5