Data Error Displayand Solutions; Command Error Displayand Remedies - MUTOH ValueJet VJ-1204 Operation Manual

7 Troubleshooting
7.2.3

Data error displayand solutions

This section describes data error messages and remedies.
A data error appears if there is a failure in data communication between your PC and the printer.
If a data error occurs, the following error message appears on the operation panel of the printer and
operation stops.
When the cause of the error is solved, the printer starts operating again.
No. Display
1 I** Error
[ ]
NOTE
• "***" in the error message is the code no. that indicates what type of error occurred.
7.2.4

Command error displayand remedies

This section describes command errors and remedies.
A command error is displayed if a certain failure occurs during analysis of the command data sent from
your PC to the printer.
If a command error occurs, the following error message appears on the operation panel of the printer and
operation stops.
When the error is solved, the printer starts operating again.
No. Display
1 MH** Error
[ ]
NOTE
• "***" in the error message is the code no. that indicates what type of error occurred.
• The command code representing the error occurred may be indicated in [ ].
• For the settings on your PC side, refer to the Operating Manual attached with your PC.
Description
An error occurred when
receiving data.
Description
An invalid command has
been sent from the
computer.
7-12
VJ-1204 OPERATION MANUAL
Remedy
Check the communication
requirements between the
printer and your PC.
Remedy
Check that the settings on
your PC and the printer are
the same.
Reference
4.3 Menu
setups on the
operation panel
Reference
4.3 Menu
setups on the
operation panel