MUTOH ValueJet VJ-1204 Operation Manual page 157

VJ-1204 OPERATION MANUAL
(2) The media is crumpled during initialization
NOTE
• If the media is jammed or torn, remove it according to "7.3 The media is jammed".
No. Possible cause
1 Are you using the recommended
media?
2 Is the loading position of the media
correct?
3 Is the media loaded at an angle?
4 Are there any foreign materials such
as paper attached to the pressurizing
roller?
5 Is the printer used in an environment
other than the one specified, such as
near an air conditioner?
6 Are you using folded, torn or rolled
media?
(3) The wrong media size is set during initialization
No. Possible cause
1 Are you using the recommended
media?
2 Is the media loaded at an angle?
3 When the media is set, does it curl
upward?
4 Is the printer used in an environment
other than the one specified, such as
near an air conditioner?
5 Are you using media that has been
printed on already?
Remedy
Use the recommended media.
Set the media correctly.
Set the media straight.
Clean the pressurizing roller.
Only use the printer in an environment that
is specified for use.
Replace the media.
Remedy
Use the recommended media.
Set the media straight.
Straighten the media or set a new media.
Only use the printer in an environment that
is specified for use.
Use a new media.
7-5
7 Troubleshooting
Reference
4.2.1 Media type
3.4.2 Setting roll
media
3.4.2 Setting roll
media
6.2.2 Cleaning
the inside of the
printer
Installation
manual
4.2.2 Cautions
on handling media
Reference
4.2.1 Media type
3.4.2 Setting roll
media
3.4.2 Setting roll
media
3.4.1 Loading
roll media
4.2.1 Media type