Yamaha RX-V1800 Owner's Manual page 40

Connections
Using the· remote control
The remote control transmits a directional infrared ray.
Be sure to aim the remote control directly at the remote
control sensor on this unit during operation.
Remote control sensor
-.~J
: !
• i
~
.-1
" " - - - - r - - - ! - -
--I-C:S
Approximately 6 m (20 ft) . . 30°
I
30°
..
_--------------
Display window (@)
Shows the name of the selected input source that you can
control.
Infrared window (@)
Outputs infrared control signals. Aim this window at the
component you want to operate.
Transmit indicator (@)
Flashes while the remote control is sending infrared
signals.
Operation mode selector (@)
The function of some buttons depends on the operation
mode selector position.
AMP
Operates the amplifier function of this unit.
SOURCE
Operates the component selected with an input
selector button (see page 101).
TV
Operates the TV assigned to either DTV feBL or
PHONO (see page 100).
36
En
Notes
• Do not spill water or other liquids on the remote control.
• Do not drop the remote control.
• Do not leave or store the remote control in the following
conditions:
- places of high humidity. such as near a bath
- places of high temperatures. such as near a heater or stove
- places of extremely low temperatures
- dusty places
• To set the remote control codes for other components. see
page 102.
Openingandclos;nglhe front
panel door
When you want to use the controls behind the front panel
door, open the door by gently pressing on the lower part of
the panel. Keep the door closed when not using these
controls.
To open, press gently on the lower part of the panel.
Connections
Using the· remote control
The remote control transmits a directional infrared ray.
Be sure to aim the remote control directly at the remote
control sensor on this unit during operation.
Remote control sensor
-.~J
: !
• i
~
.-1
" " - - - - r - - - ! - -
--I-C:S
Approximately 6 m (20 ft) . . 30°
I
30°
..
_--------------
Display window (@)
Shows the name of the selected input source that you can
control.
Infrared window (@)
Outputs infrared control signals. Aim this window at the
component you want to operate.
Transmit indicator (@)
Flashes while the remote control is sending infrared
signals.
Operation mode selector (@)
The function of some buttons depends on the operation
mode selector position.
AMP
Operates the amplifier function of this unit.
SOURCE
Operates the component selected with an input
selector button (see page 101).
TV
Operates the TV assigned to either DTV feBL or
PHONO (see page 100).
36
En
Notes
• Do not spill water or other liquids on the remote control.
• Do not drop the remote control.
• Do not leave or store the remote control in the following
conditions:
- places of high humidity. such as near a bath
- places of high temperatures. such as near a heater or stove
- places of extremely low temperatures
- dusty places
• To set the remote control codes for other components. see
page 102.
Openingandclos;nglhe front
panel door
When you want to use the controls behind the front panel
door, open the door by gently pressing on the lower part of
the panel. Keep the door closed when not using these
controls.
To open, press gently on the lower part of the panel.