Yamaha RX-V1800 Owner's Manual page 22

Connections
• Connecting the speaker cable
1
Remove approximately 10 mm (0.4 in) of
insulation from the end of each speaker
cable and then twist the exposed wires of the
cable together to prevent short circuits.
5
Hook the speaker terminal wrench onto
WRENCH HOLDER on the rear panel of this
unit when not in use.
10 mm (0.4 in)
I
2
Loosen the knob using the supplied speaker
terminal wrench.
Speaker terminal wrench
Red: positive (+)
Black: negative (-)
3
Insert one bare wire into the hole on the side
of each terminal.
4
Tighten the knob to secure the wire using the
supplied speaker terminal wrench.
18
En
• Connecting to the SP2 speaker
terminals
Connect Zone 2 or Zone 3 speakers to these terminals (see
page Ill).
1
Open the tab.
Red: positive (+)
Black: negative (-)
2
Insert one bare wire into the hole on the
terminal.
3
Close the tab to secure the wire.
Connections
• Connecting the speaker cable
1
Remove approximately 10 mm (0.4 in) of
insulation from the end of each speaker
cable and then twist the exposed wires of the
cable together to prevent short circuits.
5
Hook the speaker terminal wrench onto
WRENCH HOLDER on the rear panel of this
unit when not in use.
10 mm (0.4 in)
I
2
Loosen the knob using the supplied speaker
terminal wrench.
Speaker terminal wrench
Red: positive (+)
Black: negative (-)
3
Insert one bare wire into the hole on the side
of each terminal.
4
Tighten the knob to secure the wire using the
supplied speaker terminal wrench.
18
En
• Connecting to the SP2 speaker
terminals
Connect Zone 2 or Zone 3 speakers to these terminals (see
page Ill).
1
Open the tab.
Red: positive (+)
Black: negative (-)
2
Insert one bare wire into the hole on the
terminal.
3
Close the tab to secure the wire.