Chapter 6
Restoring the System
This chapter describes the procedures required to restore the system after FRU
maintenance. See this chapter, as required, when performing maintenance on each
FRU described in Chapter 8 onward.
Restoring the Chassis
■
Incorporation of the SPARC M10-4S chassis (possible only in a system with a
■
building block configuration)
Incorporating a Chassis and I/O Device into a Physical Partition
■
Powering On the Physical Partition Requiring Maintenance
■
Starting the Entire System
■
6.1
Restoring the Chassis
This section describes operations required to restore the chassis.
6.1.1
Installing the power cord
If the power cord of the SPARC M10-4/M10-4S was removed to perform the
maintenance work, connect the power cord and then attach the cable clamp to the
power cord.
1.
Connect the power cord to the PSU backplane unit.
87