Chapter 6
Restoring the System
This chapter describes the procedures required to restore the system after FRU
maintenance. See this chapter, as required, when performing maintenance on each
FRU described in Chapter 8 onward.
Restoring the Chassis
■
Incorporating a SPARC M10-4/M10-4S FRU into the System with the replacefru
■
Command
Diagnosing a Replacement FRU
■
Restoring XSCF Setting Information
■
Incorporating a Chassis and I/O Device into a Physical Partition
■
Returning the Mode Switch to Locked Mode
■
Powering On the Physical Partition Requiring Maintenance
■
Starting the Entire System
■
6.1
Restoring the Chassis
This section describes operations required to restore the chassis.
6.1.1
Installing the power cord
If the power cord of the SPARC M10-4/M10-4S was removed to perform the
maintenance work, connect the power cord and then attach the cable clamp to the
power cord.
For system-stopped/all power-off cold maintenance, install all the SPARC M10-4S
power cords.
1.
Connect the power cord to the PSU backplane unit.
Insert the power cord straight into the PSU backplane unit all the way.
105