Dealing With Network Faults - Avery Berkel IM Series User Instructions

14.7 Dealing with network faults

14.7

Dealing with network faults

The server constantly monitors the network and when it detects a network error it will
bleep.
If the cause is a faulty client machine
1. switch off or disconnect the faulty machine.
2. At the server go to Manager Mode.
NETWORK
3. Press
Enter
4. Press
If the cause is a client machine that has been switched off, then switch the client back on.
Error message
Memory Full
Comms Error
Map Error
Incomplete Error
Local Mode
No Server
IM series User Instructions
to display the network map.
MAP
to stop the bleep.
Cause
The system cannot store any
more PLUs
Breakdown in communications
between machines.
The machine corresponding to
that position is off line.
The PLU file in the client
machine does not match the
server PLU file.
The machine is in Local Mode. To reinstate the client
Client machine is not
communicating with server
machine.
Action
Delete any old, unwanted PLUs.
Check network map
Check the network map.
Check the network connections
and set the machine ID if
necessary.
Perform a Network Dump at the
server (see section 14.9 page
222).
see page 221
Check network cable.
Set machine to operate in Local
Mode.
219
Communications