Auto Configure - Avery Berkel IM Series User Instructions

214
14.3

Auto configure

You can use auto configure to quickly set up a network of machines that are programmed
with the factory default IP address and have been connected to an ethernet hub.
Adding a machine to the network
You can add machines to the network up to the maximum allowed (10). When you select
Auto Configure at the new machine it will automatically be allocated the next machine
ID.
Updating the PLU file
You can perform a Network Dump from the server if the PLU file at the new client
machine does not match the server PLU file (see
Each time the client machine uses a PLU it fetches the PLU data from the server and the
PLU file at the client machine is updated.
If you choose not to perform a network dump, the PLU file at the client will gradually be
updated to match the server.
Manager Mode
1
Enter
2
Enter
3
Communications
5
or
1
or
section 14.9, page

Auto Configure

Are You Sure? No
Please Wait ....
Completed
14.3 Auto configure
222).
IM series User Instructions