Default Gateways - Lenovo Flex System Fabric CN4093 Application Manual

4. If configuring VLANs, specify a VLAN for the interface.
5. At the prompt, enter y to enable the IP interface, or n to leave it disabled:
6. The system prompts you to configure another interface:

Default Gateways

1. At the prompt, select an IP default gateway for configuration, or skip default
gateway configuration:
2. At the prompt, enter the IPv4 address for the selected default gateway:
3. At the prompt, enter y to enable the default gateway, or n to leave it disabled:
4. The system prompts you to configure another default gateway:
© Copyright Lenovo 2015
This prompt appears if you selected to configure VLANs back in Part 1:
Current VLAN: 1
Enter new VLAN [1­4094]:
Enter the number for the VLAN to which the interface belongs, or press <Enter>
without specifying a VLAN number to accept the current setting.
Enable IP interface? [y/n]
Enter interface number: (1­128)
Repeat the steps in this section until all IP interfaces have been configured. When
all interfaces have been configured, press <Enter> without specifying any interface
number.
IP default gateways:
Enter default gateway number: (1­3, 4)
Enter the number for the IP default gateway to be configured. To skip default
gateway configuration, press <Enter> without typing a gateway number and go to
"IP Routing" on page 54.
Current IP address: 0.0.0.0
Enter new IP address:
Enter the IPv4 address in dotted decimal notation, or press <Enter> without
specifying an address to accept the current setting.
Enable default gateway? [y/n]
Enter default gateway number: (1­4)
Repeat the steps in this section until all default gateways have been configured.
When all default gateways have been configured, press <Enter> without specifying
any number.
53
Chapter 2: Initial Setup