Configuration Guidelines
Auto Monitor Guidelines
Manual Monitor Guidelines
© Copyright Lenovo 2015
This section provides important information about configuring Layer 2 Failover.
Note: Auto Monitor and Manual Monitor are mutually exclusive. They cannot both
be configured on the switch.
Any specific failover trigger may monitor static trunks only or LACP trunks
only, but not both.
All external ports in all static or LACP trunks added to any specific failover
trigger must belong to the same VLAN.
A maximum of two LACP keys can be added per trigger.
When VLAN Monitor is on, the following additional guidelines apply:
All external ports in all static or LACP trunks added to a specific failover
trigger must belong to the same VLAN and have the same PVID.
Different triggers are not permitted to operate on the same VLAN.
Different triggers are not permitted to operate on the same internal port.
For each port in each trunk in a specific failover trigger, the trigger will
monitor the STP state on only the default PVID.
A Manual Monitor can monitor only external ports.
Any specific failover trigger can monitor external ports only, static trunks only,
or LACP trunks only. The different types cannot be combined in the same
trigger.
A maximum of two LACP keys can be added per trigger.
Management ports, FC ports, and stacking ports cannot be monitored.
Control ports for different triggers must not overlap. Monitor ports may
overlap.
Chapter 34: Layer 2 Failover
469