Listing Current Users; Logging In To An End User Account; Protected Mode - Lenovo Flex System Fabric CN4093 Application Manual

Listing Current Users

Logging In to an End User Account

Protected Mode

74
CN4093 Application Guide for N/OS 8.2
The show access user
or not each user is currently logged into the switch.
CN4093# show access user
Usernames:
user ­ Enabled ­ offline
oper ­ Disabled ­ offline
admin ­ Always Enabled ­ online 1 session
Current User ID table:
1: name USERID , ena, cos admin , password valid, offline
2: name jane , ena, cos user , password valid, online
3: name john , ena, cos user , password valid, online
Once an end user account is configured and enabled, the user can login to the
switch, using the username/password combination. The level of switch access is
determined by the Class of Service established for the end user account.
Protected Mode settings allow the switch administrator to block the management
module from making configuration changes that affect switch operation. The
switch retains control over those functions.
The following management module functions are disabled when Protected Mode
is turned on:
 External Ports: Enabled/Disabled
 External management over all ports: Enabled/Disabled
 Restore Factory Defaults
 New Static IP Configuration
In this release, configuration of the functions listed above are restricted to the local
switch when you turn Protected Mode on. In future releases, individual control
over each function may be added.
Note: Before you turn Protected Mode on, make sure that external management
(Telnet) access to one of the switch's IP interfaces is enabled.
Use the following command to turn Protected Mode on:
CN4093(config)# protected­mode enable
If you lose access to the switch through the external ports, use the console port to
connect directly to the switch, and configure an IP interface with Telnet access.
command displays defined user accounts and whether