Evb Configuration - Lenovo Flex System Fabric CN4093 Application Manual

EVB Configuration

1. Create an EVB profile.
2. Enable Reflective Relay.
3. Enable VSI discovery.
4. Add EVB profile to port.
5. Configure ECP retransmission interval.
6. Set VSI database information.
314
CN4093 Application Guide for N/OS 8.2
This section includes the steps to configure EVB based on the following values:
 Profile number: 1
 Port number: 1
 Retry interval: 8000 milliseconds
 VSI Database:
Manager IP: 172.31.37.187

Port: 80

Note: VSI Database can be accessed via HTTP or HTTPS. The manager IP can
be configured with an IPv4 or IPv6 address.
CN4093(config)# virt evb profile 1 (Enter number from 1‐16)
CN4093(conf­evbprof)# reflective­relay
CN4093(conf­evbprof)# vsi­discovery
CN4093(conf­evbprof)# exit
CN4093(config)# interface port 1
CN4093(config­if)# evb profile 1 (Enter EVB profile ID)
CN4093(config­if)# exit
CN4093(config)# ecp retransmit­interval 8000
(Enter retransmission interval in milliseconds (100‐9000)
CN4093(config)# virt evb vsidb 1
CN4093(conf­vsidb)# protocol {http|https}(Select VSI database protocol; default is HTTP)
CN4093(conf­vsidb)# host 172.31.37.187 [data­port|extm­port|mgt­port]
CN4093(conf­vsidb)# port 80
CN4093(conf­vsidb)# filepath "vsidb"
CN4093(conf­vsidb)# filename "all.xml" (Set VSI database file name)
CN4093(conf­vsidb)# update­interval 30 (Set update interval in seconds)
CN4093(conf­vsidb)# exit
(Set VSI database Manager IP)
(Set VSI database Manager port)
(Set VSI database document path)