Lenovo Flex System Fabric CN4093 Application Manual page 484

Task 1: Configure CN4093 1
1. On CN4093 1, configure the interfaces for clients (174.14.20.110) and servers
2. Configure Virtual Interface Routers.
3. Enable VRRP Hot Standby.
4. Configure VRRP Group parameters. Set the VRRP priority to 101, so that this
5. Turn off Spanning Tree Protocol globally..
484
CN4093 Application Guide for N/OS 8.2
(10.1.1.110).
CN4093(config)# interface ip 1
CN4093(config­ip­if)# ip address 174.14.20.110(Define IPv4 address for interface 1)
CN4093(config­ip­if)# enable
CN4093(config­ip­if)# exit
CN4093(config)# interface ip 2
CN4093(config­ip­if)# ip address 10.1.1.110(Define IPv4 address for interface 2)
CN4093(config­ip­if)# enable
CN4093(config­ip­if)# exit
CN4093(config)# router vrrp
CN4093(config­vrrp)# enable
CN4093(config­vrrp)# virtual­router 1 virtual­router­id 1
CN4093(config­vrrp)# virtual­router 1 interface 1
CN4093(config­vrrp)# virtual­router 1 address 174.14.20.100
CN4093(config­vrrp)# virtual­router 1 enable
CN4093(config­vrrp)# virtual­router 2 virtual­router­id 2
CN4093(config­vrrp)# virtual­router 2 interface 2
CN4093(config­vrrp)# virtual­router 2 address 10.1.1.100
CN4093(config­vrrp)# virtual­router 2 enable
CN4093(config­vrrp)# hot­standby
switch is the Master.
CN4093(config­vrrp)# group enable
CN4093(config­vrrp)# group virtual­router­id 1(Set Virtual Router ID for Group)
CN4093(config­vrrp)# group interface 1 (Set interface for Group)
CN4093(config­vrrp)# group priority 101(Set VRRP priority to 101)
CN4093(config­vrrp)# group track ports (Enable tracking on ports)
CN4093(config)# no spanning­tree stp 1
(Enable Hot Standby)
(Enable Virtual Router Group)